Extruder leaks
-
dwehrle@charter.net
- Posts: 1
- Joined: Wed Dec 16, 2020 11:13 pm
Extruder leaks
Help I have a a10t and when I went to silver pla (not sure if that has anything to do with my problem)I have leakes around all 3 of the heaters .Please Help
-
kaleaquino
- Posts: 1
- Joined: Mon Apr 26, 2021 11:47 am
Re: Extruder leaks
Hello, you can observe whether there is a leak between the nozzles or the heating block is not tightened.
If it's just the nozzle problem, just tighten it.
If the heating is fast, try to tighten it and if it cannot be restored, only replace the heating block.
Regards.
If it's just the nozzle problem, just tighten it.
If the heating is fast, try to tighten it and if it cannot be restored, only replace the heating block.
Regards.