Geeetech

hi
i just download the new FW for Geeetech A10 .and upload it to the printer.
I try the resume print but didn't work.
any thing i should know?
thanks

Hi jon.
I need more details:
1、firmware version?
2、what does "didn't work" mean?

FW v1.0.04
geeetech A10.

when i try the resume print it didn't work.
and also every time i turn on the printer it always ask me if [ resume print ? yes/on].
before i update the printer i don't have that massage when ever i turn on the printer.

FW ver.1.0.04
The resume print always show up when I turn on my printer.
Thanks.

@jonA10
you upgraded your machine from 1.0.04 to 1.1.8?

hi
I did not use the FW 1.1.8. I'm just using the FW from this forum. Because i don't know all the pin out of this board.(gt2560 REV B) by any chance do you have a pin out for this board?Because REV A and REV B are totally different.
thanks

We will send you a manual later to let you modify firmware to avoid this kind of situation from happening

Thanks you

Hi @jonA10

We've sent an introduction for firmware modification about the problems of break-resuming to your register email.
Hope this will not bother you, because there are some problems with adding files in forum PM.
Please check your email inbox and also the spam.

jonA10 wrote: ↑

Sat Aug 11, 2018 12:11 am

hi
I did not use the FW 1.1.8. I'm just using the FW from this forum. Because i don't know all the pin out of this board.(gt2560 REV B) by any chance do you have a pin out for this board?Because REV A and REV B are totally different.
thanks

You can find the pinout from Rev B here: http://www.geeetech.com/wiki/index.php/ ... 0_REVB.pdf

Wiki: http://www.geeetech.com/wiki/index.php/ ... r#Firmware