3D Touch G29 ignoring x-axis limitation - What can I DO?
Posted: Wed Mar 30, 2022 5:07 am
i got a problem while adapting my firmware for my new 3DTouch sensor.
i own a geeetech i3 pro c (dual) and i successfully installed the sensor (after a few hours...)
currently i can G28 (home all axis) fine.
but with G29 (autolevel) my x-axis is going crazy and ignores my build dimensions completely:
https://www.dropbox.com/s/ojgai588y35oh ... l.mp4?dl=0
it doesn't matter if
define X_MAX_POS 180 (current profile)
or
define X_MAX_POS 130 (just testing)
the printer always moves over the limit and the belt is tortured
suggestions are welcome
i own a geeetech i3 pro c (dual) and i successfully installed the sensor (after a few hours...)
currently i can G28 (home all axis) fine.
but with G29 (autolevel) my x-axis is going crazy and ignores my build dimensions completely:
https://www.dropbox.com/s/ojgai588y35oh ... l.mp4?dl=0
it doesn't matter if
define X_MAX_POS 180 (current profile)
or
define X_MAX_POS 130 (just testing)
the printer always moves over the limit and the belt is tortured
suggestions are welcome