Geeetech

Posted: **Thu Sep 13, 2018 1:18 am**

Hello,
After weeks of search without any clue, I come here to ask for some help.

Here a link to the video of my issue (I made an emergency stop at the end)
https://youtu.be/1MyBdcKjtmc

I use this firmware

: firmware.JPG (21.86 KiB) Viewed 17680 times

Also here my wiring

: cable bn.JPG (255.55 KiB) Viewed 17680 times

: cable rom.JPG (266.09 KiB) Viewed 17680 times

So, all is good with the selftest but, when I try to Home, the pin goes up and never do it's job..

Any clue for me?

Thanks

Posted: **Thu Mar 19, 2020 6:26 pm**

I never managed to get it working with Marlin 1. I used Marlin 2 and managed to figure it out from there. There’s an example config out there that uses the Z MAX pins instead of Z MIN but I had to change it to just use Z MIN to get it working.

Geeetech

3D touch/Pro W won't home

3D touch/Pro W won't home

Re: 3D touch/Pro W won't home