Geeetech M201 with 3 extruders
Posted: Sun Dec 25, 2016 3:22 pm
hi
this is the special firmware that geeetech made special for me to active the 3 extruders on the GTM32 RevB
on the lcd the 3th extruder temp dosent show, but its work
i mange to config in my m201 trhee options
1. two mk8 extruder ( base on the new steps)
2. two mk8 extruder ( base on the new steps) with one bowden
3. two bowden with one mk8 ( base on the new steps)
all this thanks to the new firmware that they made for me
but !!!! be aware
lot of valus are need tobe change ( and its very hard , becuse the slowly on the knob on the board )
zstep to 2560
home speed z 16
vmax z 2
ve-jerk 5
and maybe more , i dont remember, and i dont neer the printer to check
but please update about your value and how did it work for you
of curse on your on risks......
thanks
yossi
this is the special firmware that geeetech made special for me to active the 3 extruders on the GTM32 RevB
on the lcd the 3th extruder temp dosent show, but its work
i mange to config in my m201 trhee options
1. two mk8 extruder ( base on the new steps)
2. two mk8 extruder ( base on the new steps) with one bowden
3. two bowden with one mk8 ( base on the new steps)
all this thanks to the new firmware that they made for me
but !!!! be aware
lot of valus are need tobe change ( and its very hard , becuse the slowly on the knob on the board )
zstep to 2560
home speed z 16
vmax z 2
ve-jerk 5
and maybe more , i dont remember, and i dont neer the printer to check
but please update about your value and how did it work for you
of curse on your on risks......
thanks
yossi