Relay Module Setup GT2560 Board

Post Reply
craynol
Posts: 4
Joined: Mon Mar 13, 2017 5:25 am

Relay Module Setup GT2560 Board

Post by craynol » Thu Mar 23, 2017 10:12 pm

Can anyone explain the setup for installing a relay module on a GT2560 board. There are instructions online when using a ramps board but not finding specific instructions for my board. I also have an induction sensor connected to (1 of the 3) 12V+ terminals blocks. Wondering where exactly to connect the wires (V+, GND, control wire) coming from the relay module connected to the power supply. Is there a PS-ON pin on the 2560 board?
Attachments
Single_relay_module_preview_featured.jpg
Single_relay_module_preview_featured.jpg (125.67 KiB) Viewed 5804 times
power_supply_preview_featured.jpg
power_supply_preview_featured.jpg (40.61 KiB) Viewed 5804 times
Top
craynol
Posts: 4
Joined: Mon Mar 13, 2017 5:25 am

Re: Relay Module Setup GT2560 Board

Post by craynol » Thu Mar 23, 2017 10:27 pm

Here are the original instructions: http://www.instructables.com/id/Convert ... G-code-sw/
Top
Post Reply

Return to “Mods And Hacks”