Filament Guide for the Geeetech Acrylic Spool Holder

[chase]

Filament Guide.jpg (287.27 KiB) Viewed 5875 times

Designed by Robert Martin aka nukem, this is a small but functional print designed for the Geeetech Acrylic Spool Holder.
Once tapped using a 1/8th inch BSP-PL (parallel) tap, you can install the 1/8th inch BSP fittings for either 1.75mm or 3mm filaments.
Shown in the above image with two different style 1/8th inch BSP Quick Fittings, 1.75mm shown.

Printed using the Geeetech i3 Pro B with Geeetech PLA (purple)
Read more about the my make and settings over on ThingiVerse here: https://www.thingiverse.com/make:244298
Designer and stl files at ThingiVerse here: https://www.thingiverse.com/thing:1490265

Hope you find these useful as I have.

- chase -