Page 1 of 1
Where have I gone wrong?
Posted: Mon Mar 29, 2021 10:12 pm
by Neil PC
Hi all
I have installed my first roll of filament and I cannot get a decent print
I have an A20T and bought some EONO filament from Amazon
I use cura slicer.
Re: Where have I gone wrong?
Posted: Fri Apr 02, 2021 5:21 pm
by Admin
Hello, you can try to print the object below. It may be a problem with your Cura settings, depending on the printing effect.
Re: Where have I gone wrong?
Posted: Mon Apr 12, 2021 7:32 pm
by Neil PC
Thank you, I will give it a go.
I have persevered with it and got the quality as in the pictures, however i am now experiencing layer separation on the last 4 outer layers, but the rest of the print looks ok.
I apologise for the delay in coming back to you you
I have just downloaded the Easyprint lite Beta from the downloads section to see if that makes a difference, but there is very little documents about changing setting. (i have watched the videos about colour mixing)
Neil