Page 1 of 1
Unnecessary top cover
Posted: Wed Nov 14, 2018 7:09 pm
by Morogorn
Greetings,
I use SketchUp 8.0, to design a RC wheel, export as .STL and .OBJ.
Import to Repetier Host and Slice with CuraEngine.
After repair the object, the wheel show a top cover.
How remove or not print this unnecessary top cover?
I try mark "Spiralize contour", not work.
Someone can help-me?
Best regards.
Re: Unnecessary top cover
Posted: Wed Nov 14, 2018 7:18 pm
by _kaktus_
Hello.
You wrote:
Morogorn wrote: ↑Wed Nov 14, 2018 7:09 pm
After repair the object, the wheel show a top cover.
What was the reason for this operation
Maybe it introduces a problem.
Re: Unnecessary top cover
Posted: Wed Nov 14, 2018 7:33 pm
by Morogorn
Thank for your reply _Kaktus_.
The message showed is:
- 5.jpg (78.59 KiB) Viewed 29255 times
Than I try slice without repair.
Not work.
Re: Unnecessary top cover
Posted: Wed Nov 14, 2018 7:37 pm
by _kaktus_
Would you agree to share your model with us before repair?
I will see what can be done.
Re: Unnecessary top cover
Posted: Wed Nov 14, 2018 7:43 pm
by Morogorn
Re: Unnecessary top cover
Posted: Wed Nov 14, 2018 8:09 pm
by _kaktus_
Check it out now.
Re: Unnecessary top cover
Posted: Wed Nov 14, 2018 8:12 pm
by Morogorn
Wow!
Perfect! What it's mistery?
- 6.JPG (135.71 KiB) Viewed 29246 times
Re: Unnecessary top cover
Posted: Wed Nov 14, 2018 8:14 pm
by _kaktus_
- wheel2-.png (533.29 KiB) Viewed 29246 times
The best thing is that I didn't do anything with your model.
I imported in Tinkercad, set the position to the grid, and did the export.
Sometimes I ignored this message, and printed without repair.
Re: Unnecessary top cover
Posted: Wed Nov 14, 2018 8:16 pm
by Morogorn
Thank you _Kaktus_.
Re: Unnecessary top cover
Posted: Wed Nov 14, 2018 8:17 pm
by _kaktus_