Page 1 of 1
Print Slanted on the Y Axis
Posted: Sat Jan 13, 2018 2:15 am
by NightStorm1000
Hi!
I recently build my I3 Or and noticed something
My Prints come out slanted on the Y Axis
Any Idea?
Here is a Picture
https://www.dropbox.com/s/5zaqnype7wioa ... 5.jpg?dl=0
Re: Print Slanted on the Y Axis
Posted: Wed Jan 17, 2018 7:59 pm
by William
1.Check the belt of Y axis
2.Increase the voltage of Y-axis driver board A4988
- ADJUST.png (206.02 KiB) Viewed 22516 times
3.Adjust the tight of Y-axis screw
- Y motor.png (839.18 KiB) Viewed 22516 times
Re: Print Slanted on the Y Axis
Posted: Wed Jan 24, 2018 5:05 am
by NightStorm1000
Adjusting Acceleration, Jerk and Steps fixed it.
Thanks anyway!
Re: Print Slanted on the Y Axis
Posted: Thu Sep 17, 2020 4:00 am
by USMCPelto
How did you adjust those parameters?
Re: Print Slanted on the Y Axis
Posted: Sat May 15, 2021 10:09 pm
by mlauber
NightStorm1000 wrote: ↑Wed Jan 24, 2018 5:05 am
Adjusting Acceleration, Jerk and Steps fixed it.
Thanks anyway!
Yeah seriously, how did you adjust those settings? I can see them on the screen but I haven't figured out how to change them at all.
- IMG_20210512_170029.jpg (181.5 KiB) Viewed 8248 times
Re: Print Slanted on the Y Axis
Posted: Sat May 29, 2021 2:31 am
by core2k
If you are using Cura you are able to change those settings directly in the slicer! Think cura is the only slicer atm that support that feature.
Otherwise you have to change those settings in your firmware.
