XY axis angle calibration?
Posted: Thu May 04, 2017 4:01 pm
Hello,
My X and Y axes are not perpendicular. I tried to mechanically adjust it, but the Geometry (parallelograms) is not very suitable to do so. Before I start drilling and milling, I would like to ask:
1) How do you effectively adjust the perpendicularity mechanically?
2) Is there a software calibration in Marlin?
My X and Y axes are not perpendicular. I tried to mechanically adjust it, but the Geometry (parallelograms) is not very suitable to do so. Before I start drilling and milling, I would like to ask:
1) How do you effectively adjust the perpendicularity mechanically?
2) Is there a software calibration in Marlin?