Geeetech

Hi,

I have been using Repetier Host with Slic3r. I tried using the Cura engine and have a problem that I want to fix.

When I slice the job and then print the following happens:-

1. The print head moves to the bed as if to start printing.
2. The print head does not move in X/Y direction.
3. The filament retracts about 100mm.

Occasionally I have had it print without the above condition. As I want to use Cura as my preferred slicer software, I would like to resolve this issue.

Any advice will be well received.

THANKS

Daryl

what's your printer type? is your printer working well withthe slic3r engine?

Hi Mark,

Thanks for your reply. My printer is a G2 and works fine running Slic3r.
I have since found a resolution by Google search.
In the Start code of Cura, the command G92 E0 must be entered. Then Cura works fine.

Cheers

Daryl