First layer problem

gepd · Post by **gepd** » Sun May 22, 2016 7:29 am

I'm having a problem with the first layer of all my printings.
I mostly print rectangular shapes. When the print finish the first layer always has a filament that I have to cut off, to a better understanding I'll attach some images.

I'm using PLA, the extruder is at 210° in the first and other layers
and the bed 80° with the first and other layers

Can someone tell me how can I solve that?

Torm · Post by **Torm** » Mon Jun 06, 2016 7:53 pm

Hello, colleague, I see there two possible problems - low extruder temperature for your filament and low filament flow too. As a first step you need increase filament flow, for example 5-10% plus.

gepd · Post by **gepd** » Tue Jun 07, 2016 2:00 pm

Thanks Torm,
I'll try increasing the filament flow. I've already tried with higher extruder/bed temperature, but same issue

Post by **William** » Tue Jun 07, 2016 5:26 pm

You can try with lower extruder/bed temperature,like the former 200' and the latter 65'.

Geeetech

First layer problem

First layer problem

Re: First layer problem

Re: First layer problem

Re: First layer problem