Page 1 of 1
Bltouch in diagosis mode - BRAND NEW
Posted: Thu Feb 23, 2017 12:36 am
by draconisdraco
Not much to say really, just un packaged this, connected it to my Rumba ( properly) and all i'm getting is the flashing diag light.
pin moves freely.
std servo on same pins from rumba actuates fine.
Re: Bltouch in diagosis mode - BRAND NEW
Posted: Thu Feb 23, 2017 12:31 pm
by bang
Maybe you can refer to this post to have a try:
viewtopic.php?f=27&t=18371
Re: Bltouch in diagosis mode - BRAND NEW
Posted: Fri Feb 24, 2017 2:59 am
by draconisdraco
I've already done full diagnostics - the pin will not drop / lift on it's own.
Re: Bltouch in diagosis mode - BRAND NEW
Posted: Fri Feb 24, 2017 2:25 pm
by bang
If that is the case,i guess maybe there is something wrong with you firmware and wiring of 3Dtouch.
Did it do self-test when you power it on?
Re: Bltouch in diagosis mode - BRAND NEW
Posted: Sat Feb 25, 2017 1:38 am
by draconisdraco
wiring is fine, and as per the Bltouch guide.
Firmware is set exactly as per the Marlin setup guide, and is confirmed by use of a std servo.
Diagnosis is flashing the second it is powered up - i'm told the pin will lift / drop at power on - this does not happen.
Re: Bltouch in diagosis mode - BRAND NEW
Posted: Tue Mar 14, 2017 4:59 pm
by bang
Did you fix it?
Could you post a video?
Re: Bltouch in diagosis mode - BRAND NEW
Posted: Tue Mar 14, 2017 9:15 pm
by draconisdraco
hi, no - i had it refunded.
After this I metered the coil - it was open and had no resistance, so was not energising.
I have a genuine BLTouch now and it is working flawlessly.