Page 1 of 1
Print head crashing in to x & y stops
Posted: Wed Feb 03, 2016 10:40 pm
by submariner
I have just bought my first 3d printer a me creator and cannot figure out how to calibrate it so that the print head does not crash into the x & y stops and remains within the confines
of the print bed
Re: Print head crashing in to x & y stops
Posted: Thu Feb 04, 2016 4:41 pm
by Mark
do you have a picture about this? don't quite know what you means...
Re: Print head crashing in to x & y stops
Posted: Sun Feb 07, 2016 5:13 am
by submariner
Thanks for your reply Mark but I have figured out what I was doing wrong so problem solved again thanks for replying