-

Post Reply
TResell
Posts: 10
Joined: Thu Dec 24, 2015 4:35 am

-

Post by TResell » Sat Jan 16, 2016 4:11 am

-
Last edited by TResell on Sat Jun 10, 2017 1:26 am, edited 1 time in total.
Top
Mark
Posts: 1553
Joined: Thu Aug 06, 2015 9:19 am

Re: Print slightly offset from Repitier

Post by Mark » Fri Jan 22, 2016 12:05 am

check this link see if it works:
http://www.geeetech.com/forum/viewtopic ... tre#p25271
And the settings "Bed left" and "Bed front" in the picture shows will help too.
Top
Post Reply

Return to “Others”