Page 1 of 1
printing bended bridge
Posted: Thu Sep 24, 2015 8:35 pm
by steven
hello,
say i would like to print a bended bridge (picture will follow).
is it possible to do it without support and manipulate overlap layers with extrusion width?? so every layer overlaps the other so i can print in a slightly angel and make a bow
thanks
Re: printing bended bridge
Posted: Thu Sep 24, 2015 8:41 pm
by Mark
Why not lay it down and you'll need no support layers.
Re: printing bended bridge
Posted: Thu Sep 24, 2015 10:00 pm
by steven
yes i know in this simple picture it is the correct solution but in my object i want to print is not possible.
this is just schematic picture.
i wonder if it was possible to print every layer with an overlap of say 50%
thanks
Re: printing bended bridge
Posted: Thu Sep 24, 2015 10:28 pm
by Mark
it's hard to say, you can try it
Re: printing bended bridge
Posted: Fri Nov 13, 2015 11:20 pm
by dogma
How would you add support if you did need it? Sketch up?
Re: printing bended bridge
Posted: Sat Nov 14, 2015 10:01 am
by Mark
you can add it here:
- QQ截图20151114100005.jpg (239.38 KiB) Viewed 9181 times
Re: printing bended bridge
Posted: Mon Nov 16, 2015 1:26 am
by dogma
What for example would you put for the perimeters?
Re: printing bended bridge
Posted: Mon Nov 16, 2015 4:20 pm
by Mark
I can give you my settings for my G2S pro, see the attachment.