Page 1 of 1
Print will not start
Posted: Fri Jul 10, 2015 5:25 am
by Darshon
I got my a4988 today and all axis are working. I can control them. The heat bed is not getting up to temp. and I have tried printing with both heat bed on and off. the extruder gets up to temp, I can control it in repetier, but it will not print. When I click to start print it just says print is finished.
Re: Print will not start
Posted: Fri Jul 10, 2015 8:49 am
by Sherry
what's type of the printer and control board.Maybe the g-code goes wrong,i will send you the right g-code.
Re: Print will not start
Posted: Sun Jul 12, 2015 1:40 am
by Darshon
I have been able to print now, I figured it out, but the second extruder heats and will not extrude. I was sent an email from Melody at geeetech and told to flash the firmware. I am now trying to figure out how to do that. Supposedly that might fix the second extruder?
Re: Print will not start
Posted: Mon Jul 13, 2015 11:02 am
by Sherry
Darshon wrote:I have been able to print now, I figured it out, but the second extruder heats and will not extrude. I was sent an email from Melody at geeetech and told to flash the firmware. I am now trying to figure out how to do that. Supposedly that might fix the second extruder?
this is guidance for how to set up for dual extruder.