Geeetech

Hi, since i've got my me creator from christmas, I was never able to print a single good print.
Now, since a couple of weeks, my extruder does not heat, it says the temperature, the goal temperature, but never heats.
And, whenever I try to leave it to print, the nozzeler gets stuck
I'm using Abs at 250 degree Celsius
I don't understand what setting and speed to put, I would need help
I'm a beginner in 3d printing and please help me.

Only a good slicer setting can lead to good print. Tell me your nozzle diameter and filament diameter. I can share a good setting with you.
If the nozzle is really stuck, I think you have to use a thin copper wire to clean is yourself.
What is LCD displaying when heating extruder?

Hi, I have the nozzeler that came with the me creator from this site:
http://www.dx.com/p/geeetech-fdm-me-cre ... TVUayFViko
My filament is the following:
http://www.dx.com/p/pla-fluo-r-1-75-1-0 ... TVU5CFViko
And when I start to heat the extruder, the LCD shows the following: 19.7/250, and stays like this until I just turn off my 3d printer
Regards,

What about the connection of extruder? Is it connected to mainboard correctly?

I disconnected, and reconnected every wire, and my printer now works, but if you could please make me a good slicer, I use slic3r.
thank you for everything

canadianprinter wrote:I disconnected, and reconnected every wire, and my printer now works, but if you could please make me a good slicer, I use slic3r.
thank you for everything

Assume that the filament diameter is 1.75 mm, and nozzle diameter is 0.3 mm. You can refer to the attachment.
If not, please tell me, I will leave another setting that is correct.