Page 1 of 2
CONNECTING AND HEAT BED
Posted: Thu Apr 02, 2015 11:32 pm
by bandit
hI THIS IS A NEW PRINTER OUT OF THE BOX, I HAVE DOWN LOADED THE SOFTWARE FROM THE WEB SITE REPETIER HOST. AND EVEN THE EXTRUDER IS NOT HEATING UP. CAN YOU HELP ME WITH THIS PROBLEM THANKS
Re: CONNECTING AND HEAT BED
Posted: Fri Apr 03, 2015 10:11 am
by zhangxueyou
Is the extruder connected correctly? What is mainboard type?
Re: CONNECTING AND HEAT BED
Posted: Sat Apr 04, 2015 7:25 am
by bandit
THE MAIN BOARD IS SANQUINOLOLU REV. 1.3A
Re: CONNECTING AND HEAT BED
Posted: Sat Apr 04, 2015 7:27 am
by bandit
EXTRUDER IS CONNECTED RIGHT AS FAR AS I CAN SEE
Re: CONNECTING AND HEAT BED
Posted: Sat Apr 04, 2015 2:10 pm
by zhangxueyou
Did you change something of firmware? Where is your firmware from?
Re: CONNECTING AND HEAT BED
Posted: Sat Apr 04, 2015 7:26 pm
by bandit
THE FIRMWARE FROM THE REPITIER HOST WHICH WAS DOWNLOADED
Re: CONNECTING AND HEAT BED
Posted: Sat Apr 04, 2015 7:27 pm
by bandit
NOTHING WAS CHANGED, THE FIRMWARE IS REPETIER HOST
Re: CONNECTING AND HEAT BED
Posted: Tue Apr 07, 2015 3:00 pm
by zhangxueyou
RepetierHost is not firmware, it is a software used to print model online, control the printer, and save stl files as g-code file to print offline.
Re: CONNECTING AND HEAT BED
Posted: Tue Apr 07, 2015 5:25 pm
by bandit
I KEEP TELLING YOU THE PRINTER HAS NO POWER, NEED NEW POWER SUPPLY AND MAT BE NEW BOARD
Re: CONNECTING AND HEAT BED
Posted: Tue Apr 07, 2015 5:27 pm
by bandit
HELLO!
I KEEP TELLING YOU THAT THE PRINTER IS DOA. THERE IS NO POWER COMING OUT OF THE PRINTER, NO LIGHTS NOTHING