Geeetech

Here you can share you great ideas about hardware innovation. Here you can enjoy more professional and specialized services, Here is a platform for you to make a difference!
http://geeetech.net/forum/

ramps 1.4 with mega 2560 issues

http://geeetech.net/forum/viewtopic.php?f=24&t=15956

Page 1 of 1

ramps 1.4 with mega 2560 issues

Posted: Fri Jan 09, 2015 11:01 pm
by kstewart3930
i purchased the prusa i3 with ramps 1.4 on an arduino mega 2560, everything seems to be hooked up correctly and i installed marlin like the wiki page instructed but i am not able to get any movement from any of the stepper motors nor am i able to heat the bed or the hot end. im not sure if it is a firmware issue or a faulty board. any help would be appreciated,

Re: ramps 1.4 with mega 2560 issues

Posted: Fri Apr 10, 2015 8:31 pm
by aakicee
i have the drivers installed in my computer so i think that my new iduino is broken..

Re: ramps 1.4 with mega 2560 issues

Posted: Sat Apr 11, 2015 10:35 am
by zhangxueyou
aakicee wrote:i have the drivers installed in my computer so i think that my new iduino is broken..
Please tell me what your problem is?
All times are UTC+08:00
Page 1 of 1
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/