Bltouch in diagosis mode - BRAND NEW

[draconisdraco]

Not much to say really, just un packaged this, connected it to my Rumba ( properly) and all i'm getting is the flashing diag light.
pin moves freely.
std servo on same pins from rumba actuates fine.

[bang]

Maybe you can refer to this post to have a try:
viewtopic.php?f=27&t=18371

[draconisdraco]

I've already done full diagnostics - the pin will not drop / lift on it's own.

[bang]

If that is the case,i guess maybe there is something wrong with you firmware and wiring of 3Dtouch.
Did it do self-test when you power it on?

[draconisdraco]

wiring is fine, and as per the Bltouch guide.
Firmware is set exactly as per the Marlin setup guide, and is confirmed by use of a std servo.
Diagnosis is flashing the second it is powered up - i'm told the pin will lift / drop at power on - this does not happen.

[bang]

Did you fix it?
Could you post a video?

[draconisdraco]

hi, no - i had it refunded.

After this I metered the coil - it was open and had no resistance, so was not energising.

I have a genuine BLTouch now and it is working flawlessly.