printing bended bridge

[steven]

hello,

say i would like to print a bended bridge (picture will follow).
is it possible to do it without support and manipulate overlap layers with extrusion width?? so every layer overlaps the other so i can print in a slightly angel and make a bow

thanks

[Mark]

Why not lay it down and you'll need no support layers.

[steven]

yes i know in this simple picture it is the correct solution but in my object i want to print is not possible.
this is just schematic picture.
i wonder if it was possible to print every layer with an overlap of say 50%

thanks

[Mark]

it's hard to say, you can try it

[dogma]

How would you add support if you did need it? Sketch up?

[Mark]

you can add it here:

QQ截图20151114100005.jpg (239.38 KiB) Viewed 9176 times

[dogma]

What for example would you put for the perimeters?

[Mark]

I can give you my settings for my G2S pro, see the attachment.

111111config.zip

(1.66 KiB) Downloaded 403 times