settings problem with mij i3 pro c. can some one help?

[marco HL]

Hello all,

I will introduce myself, I am marco. I come from Holland. My English is not very good so there will undoubtedly are a few glitches. I understand another okay, just lies in the syntax. I translate, therefore the most with google translate. Here, too, are often errors in terms of syntax. srry about that but I will do my best. I have now for 4 months a 3d printer. I have the Geeetech i3 pro c dual extruder.

so i have now for 4 months a 3D printer, but i can notthing with it because i think that my settings are wrong. I've tried everything. Googled a lot and YouTube videos watched, but I get the settings just not good. So I made a movie of my settings and placed it on youtube.

my question is, if anyone would like to help me with adjusting the settings. So I finally can start making use of my printer.

Here is the link to mij youtube movie:

https://www.youtube.com/watch?v=ElVB5c_IZOw

I hope someone can give me further allows / wants to help.

Sincerely, Marco


(I did not know where this issue belonged in the topic because it can involve many problems)

[Mark]

Sorry for replying you so late. I watched your vedio ,later we will send you a configuration file ,you can laod it and print again to see the result.

[consta]

Hello Mark, I have the same problem could you help me by sending the correct settings,please send asap, thanks.


consta

[consta]

Hello,Mark I have the same problem could you help me by sending the correct settings,is possible send asap, I have this problem for long time, thanks.


consta

[Mark]

Hi, I'll send the file of my I3x to you, just only for your reference.

[consta]

Hi Erick thanks to replay.


consta