Page 1 of 1
Z axis problem
Posted: Thu Nov 10, 2016 8:02 pm
by ket0ne_
I have a problem with z axis. When i tight bearing holders top plates they wrench and jam the z axis. when i loose the top plates bolts it moves well...
Re: Z axis problem
Posted: Fri Nov 11, 2016 10:14 am
by William
Hi,
You can disassemble this part,then reinstall it to check it's a screw mounting problem or some issues on the hardware.
Re: Z axis problem
Posted: Fri Nov 11, 2016 10:47 am
by ket0ne_
Same problem both sides. I think that acrylic parts causes it.
Re: Z axis problem
Posted: Fri Nov 11, 2016 11:17 am
by William
You can check it with the manual carefully,or maybe you missed some mounting details.
Re: Z axis problem
Posted: Fri Nov 11, 2016 11:41 am
by ket0ne_
Mounted just like manual says.
Re: Z axis problem
Posted: Sat Nov 12, 2016 2:09 am
by ket0ne_
Those z axis bearing holders are very bad design... Always stuck the z axis!!
Re: Z axis problem
Posted: Sat Jan 21, 2017 3:51 am
by waldamore
maybe sanding helps?