Geeetech

I have purchased a Geeetech Rostock 301, I have found all the instructions to build the printer with a few common sense changes as instruction are not correct in some places , plus the kit only comes with 5 x M3 x 25 hex screws when you actually need 8 . my issue is I have tried to contact 3 different sections in geeetech with no replies for 3 days so far

one of the questions I am trying to find answer for is ..... on page 17 on one of the instructions, it states ;;;;;;; Don’t forget to stick the heat sink (#44) on the chip of the A4988 stepper motor driver
with sticker (#43).

I have now found the answer to my question about the heat sinks plus I went out and spent $2.90 and brought some replacement screws so I was able to finish builder my printer

Congratulations

Hello,
Bonjour,

You will find the original text translated into English following this original French text.

Vous trouverez le texte original traduit en anglais à la suite du présent texte original en français.

Est-ce qu’aujourd'hui vous réussissez de belles impressions avec votre imprimante delta Geeetech Rostock 301 (M301) ?

Pas moi, j'ai acheté le 24 septembre 2016 !

Voir des pistes de solution dans le sujet suivant :

http://www.geeetech.com/forum/viewtopic ... 27&t=18578

Cordialement,

L'ami René
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Hello,

Excuse me, I am unilingual francophone and I use Google translator to translate the texts of the forum in French and to write to you in English. Thank you for your understanding and your indulgence for these texts translated mechanically!

Do you make today beautiful prints with your Geeetech Rostock 301 (M301) delta printer?

Not me, I bought on September 24, 2016!

See possible solutions in the following topic:

http://www.geeetech.com/forum/viewtopic ... 27&t=18578

Cordially,

Friend René