I3 Pro B X and Y rods

Post Reply
sutto55
Posts: 1
Joined: Mon May 30, 2016 11:43 am

I3 Pro B X and Y rods

Post by sutto55 » Tue May 31, 2016 8:16 am

I found when building my Pro B that the documentation says to use the 390mm smooth rods for the Y axis and 410mm rods for the X axis.

These should be the other way around. If they are not swapped the Y axis only has 180mm of travel.

Other than that the build was quite easy and I am very pleased with the results of the prints.
Top
Toy
Site Admin
Posts: 116
Joined: Mon May 16, 2016 8:40 am

Re: I3 Pro B X and Y rods

Post by Toy » Tue May 31, 2016 9:18 am

Thanks for your feedback, we'll test it.
Top
Suggy
Posts: 31
Joined: Tue Oct 11, 2016 1:13 am

Re: I3 Pro B X and Y rods

Post by Suggy » Wed Oct 19, 2016 2:09 pm

Is this the case? if so it will answer my post I'm waiting to be approved
Top
Post Reply

Return to “Assembly”