Geeetech

I have a Geeetech Prusa I3 Pro X. My problem is the Y axis keeps getting stuck. When printing the platform will get stuck for a sec and really mess up my prints. I replaced the all the bearings on the build platform and greased the rods at least half a dozen times. Also messed around with the tension on the drive belt. It will print good for the first couple a layers than start making a grinding sound and become offset. This is really frustrating and not sure what to try next. Any help will be great!

Thanks,
Jay

I think you need to check the driver voltage of the driver board, see if it's proper or not. Check out this link to adjust it:
http://www.geeetech.com/forum/viewtopic ... 17&t=17038