Homing Rostock Mini G2s

[Roadracers]

Assembly wasn't a problem. Firmware wasn't an issue either. Now I am trying to home the printer for the first time. I was able to get the height set and even homed all three points. Once I go back to the center point the print head doesn't touch the bed, so it is concave. I adjusted the DELTA_SMOOTH_ROD_OFFSET up two levels and it finally touches the center. Problem is now the other three points no longer touch. So I went thru the process again and the same results.

Can anyone help me with understanding this?

[Mark]

this link might help you a bit..
http://www.geeetech.com/forum/viewtopic ... 20&t=17505

[Roadracers]

Can you offset by fractions? Such as 2.1?

[Mark]

yes no problem, I thought it can only use integers as you before, but the truth is, both will work.