Geeetech

Prusa i3x not working

nr. 1 the end stop

Y and X axis End stopper seem not been working - its like they still have force on them when they hit the end stop



nr.2 Z axis not moving

Z axis motors are doing somtheng but not moving the z axis
(not) i can turn the bearing on the both sides even tough the screws are lock tied - ( did already use some wd40 on roads. )



nr.3 Heat beed and extruder not heating

1. the endstops, is your home working well? if it is then don't worry about this.
2. is your Z axis motor working well when removing the coupling? and the 2 sides of your X axis are the same height to the heatbed? if not it will hard to move the Z axis up and down. And the Z axis driver will need more power to drive the Z axis cause it has two motors.
3. as for this one, check this link first:
http://www.geeetech.com/forum/viewtopic ... 19&t=17039

1. yes the end stops works. its was just my thinking they where not working
2. just needed to tight the screws on the bearing more and put more wd-40 on it
3. i had the thermistor for the heater of the extruder on the wrong place one the motherboard