Different lenfth for diagonal rods on G2S PRO
Posted: Mon Jan 11, 2016 7:18 pm
HI
I assembled my new G2S PRO and make it works.
I made some little prints with success, but when I tried the second extruder I experienced difficulties.
In fact my spider is not always horizontal but has a varrying tilt. When it is near the Z axis the hot_end 1 is closer to the bed and when it is at the opposite of the Z axis the hot-end 2 is closer to the bed. It make the level adjustment impossible for the two hot-ends.
I investigate the problem and found that 5 of the 6 hot end has length of 198.8 mm and the last one 196mm. So like that my printer is not really usable.
Where could I find a diagonal rod the fit my the other ones ?
I assembled my new G2S PRO and make it works.
I made some little prints with success, but when I tried the second extruder I experienced difficulties.
In fact my spider is not always horizontal but has a varrying tilt. When it is near the Z axis the hot_end 1 is closer to the bed and when it is at the opposite of the Z axis the hot-end 2 is closer to the bed. It make the level adjustment impossible for the two hot-ends.
I investigate the problem and found that 5 of the 6 hot end has length of 198.8 mm and the last one 196mm. So like that my printer is not really usable.
Where could I find a diagonal rod the fit my the other ones ?
