I3 pro C:X carriage can not trigger the endstop?!
Posted: Wed Dec 09, 2015 4:13 pm
Hello guys, some customers who bought I3 pro C might run into this problem: the X carriage is too short to trigger the endstop!
Don't worry, I'll give you a solution here: add a printed plastic trigger to the X carriage and you can solve it. Or you can find something similiar to replace it too.
Check the picture below:
We'll provide the endstop trigger in the kit from now on, so you needn't to worry about that if you want to buy it these days, thanks!
Don't worry, I'll give you a solution here: add a printed plastic trigger to the X carriage and you can solve it. Or you can find something similiar to replace it too.
Check the picture below:
- 标注.jpg (82.51 KiB) Viewed 25182 times
- IMG_2679.JPG (327.72 KiB) Viewed 25182 times