Updated instructions for X carriage assembly in M201
Posted: Wed Dec 09, 2015 3:38 pm
If anyone bought the I3 M201, and find the nozzle is crashed to the bed far before the endstop is triggered:
Please come to 18. Assembly of the extruder carriage and assemble the X carriage like this:
Step1.fix the 4 Bearing Brackets on the back of the X Carriage loosely with M3x6mm screws. Insert the linear bearing into the slot and screw the bracket tightly.
Please notice the front and back of the plate.
The following steps differs from the video, please build based on this manual.
Step2.Fix the belt mount on the back of the carriage with 2 M3x 12mm screws and M3 hex nuts.
Step3. Fix the extruder holder on the front side of the X carriage using M4x6mm screws.
That's all.
Or you can contact the sales to get a new PDF instruction, thanks!
- 1.jpg (811.51 KiB) Viewed 32004 times
Step1.fix the 4 Bearing Brackets on the back of the X Carriage loosely with M3x6mm screws. Insert the linear bearing into the slot and screw the bracket tightly.
- 2.jpg (226.55 KiB) Viewed 32004 times
- 3.jpg (235.37 KiB) Viewed 32004 times
Please notice the front and back of the plate.
The following steps differs from the video, please build based on this manual.
Step2.Fix the belt mount on the back of the carriage with 2 M3x 12mm screws and M3 hex nuts.
- 4.jpg (222.74 KiB) Viewed 32004 times
Step3. Fix the extruder holder on the front side of the X carriage using M4x6mm screws.
- 5.jpg (173.27 KiB) Viewed 32004 times
- 6.jpg (209.87 KiB) Viewed 32004 times
- 7.jpg (160.19 KiB) Viewed 32004 times
- 8.jpg (152.64 KiB) Viewed 32004 times
Or you can contact the sales to get a new PDF instruction, thanks!