Updated instructions for X carriage assembly in M201

[Mark]

If anyone bought the I3 M201, and find the nozzle is crashed to the bed far before the endstop is triggered:

1.jpg (811.51 KiB) Viewed 31994 times

Please come to 18. Assembly of the extruder carriage and assemble the X carriage like this:

Step1.fix the 4 Bearing Brackets on the back of the X Carriage loosely with M3x6mm screws. Insert the linear bearing into the slot and screw the bracket tightly.

2.jpg (226.55 KiB) Viewed 31994 times

3.jpg (235.37 KiB) Viewed 31994 times

Please notice the front and back of the plate.
The following steps differs from the video, please build based on this manual.

Step2.Fix the belt mount on the back of the carriage with 2 M3x 12mm screws and M3 hex nuts.

4.jpg (222.74 KiB) Viewed 31994 times

Step3. Fix the extruder holder on the front side of the X carriage using M4x6mm screws.

5.jpg (173.27 KiB) Viewed 31994 times

6.jpg (209.87 KiB) Viewed 31994 times

7.jpg (160.19 KiB) Viewed 31994 times

8.jpg (152.64 KiB) Viewed 31994 times

That's all.
Or you can contact the sales to get a new PDF instruction, thanks!

[BJM]

interestingly my parts were not green or blue but black and after a little head scratching I managed to mount it so it works

[Shreveport]

Building Instructions of Geeetech Prusa I3 M201 (Version ) CONTENT Safety (X idler end) Assembly of the extruder carriage Assemble the the X&Z axis your Prusa i3 HEPHESTOS and update it with the latest innovations that appear in .





AES Success