Page 1 of 1
Prusa I3 Aluminium - Cut out for LCD display backwards
Posted: Fri Nov 13, 2015 7:23 pm
by eikeland
Hi,
I try to assemble my I3 Alum. kit, but it is a manufacture issue for the LCD Display cutout, it's bakwards (mirrored).
Please see the image:
- Cut out for LCD display backwards
- IMG_0087c.jpg (215.49 KiB) Viewed 8813 times
Re: Prusa I3 Aluminium - Cut out for LCD display backwards
Posted: Sat Nov 14, 2015 10:13 am
by Mark
maybe you have the wrong instructions, check PDF page19 here:
- QQ截图20151114100745.jpg (198.49 KiB) Viewed 8810 times
- QQ截图20151114101314.jpg (278.16 KiB) Viewed 8810 times
Re: Prusa I3 Aluminium - Cut out for LCD display backwards
Posted: Sat Nov 14, 2015 7:00 pm
by eikeland
Hi,
I do not have that instruction.
Could you please post or email me the latest instruction?
Re: Prusa I3 Aluminium - Cut out for LCD display backwards
Posted: Sat Nov 14, 2015 10:54 pm
by SAMS
Hi, I can confirm this issue, I'm running in the very same problem...
Apparently, we are not alone
http://www.geeetech.com/forum/viewtopic ... 22&t=16942
http://www.geeetech.com/forum/viewtopic ... 22&t=16926
Where can we find the good instruction for the new FULL aluminum Prusa I3 ?
Sanguino headers are 90° so it collide X axis motor if you mount as instructed.
- sanguino.png (378.89 KiB) Viewed 8782 times
Re: Prusa I3 Aluminium - Cut out for LCD display backwards
Posted: Mon Nov 16, 2015 5:52 pm
by Mark
For those who's headers are 90°, you can mount it as this file shows:
And the latest PDF for this printer is here(please ignore the old pictures in it, just mount it on the left of your frame)
Re: Prusa I3 Aluminium - Cut out for LCD display backwards
Posted: Mon Nov 16, 2015 11:23 pm
by SAMS
There is no M3x40 left (There were only 2), I have 2 M3 washer left and I never had those aircraft spacers nor the long spacer tubes...
So I just made 6 holes (4 taped for the board) at the right place, like on the old frame.
Other problems, the fan have 3 pins connectors with the wrong spacing for the 2 pins headers and end-stop have one joined pins connector instead 2 single pin connector.
I removed the connectors plastic shell and plugged the pins directly to the header pins
I'm not sure anyone even try to fully assemble this new modified full aluminum kit...