Geeetech

I have a Acrylic Geeetech I3 Pro 3D printer. I was have recently replaced the extruder and now I am having an error when the printer starts up. I was wanting to look at the wiring diagram to make sure that I wired the extruder up correctly. I noticed that the wiring diagram is not for the RAMPS board that I am using. Is there a way that I can see the wiring instructions for older generations of the 3D printer which did use the RAMPS board?


Thanks in advance

Jerry

How about the link here:
http://www.geeetech.com/wiki/index.php/Ramps1.4
If not, could you post a picture of your board here?