Geeetech

Here you can share you great ideas about hardware innovation. Here you can enjoy more professional and specialized services, Here is a platform for you to make a difference!
http://geeetech.net/forum/

XZ-plate mirrored?

http://geeetech.net/forum/viewtopic.php?f=22&t=16926

Page 1 of 1

XZ-plate mirrored?

Posted: Thu Sep 10, 2015 5:43 am
by pairair
I just finished assembly of my Prusa i3 aluminum. I was a bit concerned that if the LCD should face the right direction, the holes for attaching the main board would be on the wrong (left) side.
Now I realize that the USB connector blocks the travel of the X-axis stepper... So, someone drilled some holes on the wrong side?

/Per

Re: XZ-plate mirrored?

Posted: Fri Sep 11, 2015 9:39 pm
by Mark
Seems you are right, it's...mirrored :shock:
All times are UTC+08:00
Page 1 of 1
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/