cannot install the control board, instruction is not clear

[peter]

I bought the Arcylic I3 Pro B, however, the control board is different with the instruction on the Geeetech website, the part # of the control board is GT2560, please email me the detailed instruction how to install this board and how to connect all the cables to this board with clear pictures. On the PSU, there is a yellow warning label for 110V/220V selection , but I do not see any switch to select the voltage. The online instruction has many errors and incomplete, has to be dramatically improved. Do you have technical support in US?

[Sherry]

hi,peter.arcylic i3 pro b equipo with 2 different types control board.one is ramps 1.4 ,another is gt2560. and i glance over our wiki page,it's not complete.Thank you for you suggestions, we will improve it later.the instruction for gt2560 has been sent to you mailbox.please check.the 110V/220V selection is in the psu box,you need to use a tool to change the switch.

[artemarva]

Hello, I too have the GT2560 Board. I will need the different instructions as well, please email it to me too.

[Sherry]

Hello, I too have the GT2560 Board. I will need the different instructions as well, please email it to me too.

hi,could you tell me your printer type?or you can refer to wiki page:http://www.geeetech.com/wiki/index.php/GT2560.
Instruction for 13 pro with gt2560 is complete in our website.

[chasedwa]

I also need wiring diagram for the gt 2560 printer control board thanks

[Mark]

you guys can find it here:
http://www.geeetech.com/wiki/index.php/GT2560