Page 1 of 1
I3A mdoel x axis can't return home.
Posted: Sun May 17, 2015 9:06 pm
by acep001
Hi,
The x axis motor can't work properly, it can rotate a little bit but can't return home. Any clues?
CP
Re: I3A mdoel x axis can't return home.
Posted: Mon May 18, 2015 8:39 am
by zhangxueyou
Hi,CP
You should check if the endstops are connected correctly.
Re: I3A mdoel x axis can't return home.
Posted: Mon May 18, 2015 10:36 am
by acep001
Hello,
I follow the manual to assemble the end stop, blue one. I observed that the machine can't detect the x axis position correctly. My main board is Sanguinololu.
CP