I3A mdoel x axis can't return home.

Post Reply
acep001
Posts: 3
Joined: Sun May 17, 2015 3:49 pm

I3A mdoel x axis can't return home.

Post by acep001 » Sun May 17, 2015 9:06 pm

Hi,

The x axis motor can't work properly, it can rotate a little bit but can't return home. Any clues?

CP
Top
zhangxueyou
Posts: 1405
Joined: Fri Feb 06, 2015 1:33 pm

Re: I3A mdoel x axis can't return home.

Post by zhangxueyou » Mon May 18, 2015 8:39 am

Hi,CP
You should check if the endstops are connected correctly.
Top
acep001
Posts: 3
Joined: Sun May 17, 2015 3:49 pm

Re: I3A mdoel x axis can't return home.

Post by acep001 » Mon May 18, 2015 10:36 am

Hello,

I follow the manual to assemble the end stop, blue one. I observed that the machine can't detect the x axis position correctly. My main board is Sanguinololu.

CP
Top
Post Reply

Return to “Assembly”