Page 1 of 1
Acrylic Prusa I3 build instruction(8mm)
Posted: Mon Apr 27, 2015 7:24 am
by nagromlt
For the instructions on mounting the Y-motor on the Geeetech
wiki page, it lists M3x16 screws to mount the motor plate but the image/picture shows M3x20 screws...
Which is the correct screw to use
Re: Acrylic Prusa I3 build instruction(8mm)
Posted: Mon Apr 27, 2015 4:53 pm
by zhangxueyou
16 is correct.
Re: Acrylic Prusa I3 build instruction(8mm)
Posted: Mon Aug 03, 2015 11:37 am
by Warfey
Im stuck at attaching the Y-Motor. As the instructions state, I pulled the length 16 screws to use, but they are simply not long enough. Unless I was super unlucky and the little baggy with the screws in them were mislabled. I checked and the M3x20 screws fit perfectly.
Re: Acrylic Prusa I3 build instruction(8mm)
Posted: Tue Aug 04, 2015 6:55 am
by nagromlt
Yeah I ended up using the 16 screws.
