Ciao,
I've just complete my new i3 printer, but when I plug it on my Windows 7 PC it found "arduino mega 2560" but I do not found any driver that allow me to use it!!
I've also installed repetier but, of course, I cannot talk with printer...
First Power On & windows drivers
-
zhangxueyou
- Posts: 1405
- Joined: Fri Feb 06, 2015 1:33 pm
Re: First Power On & windows drivers
Hi, you should manually install 2560.
Before that , you should intall Arduino IDE 1.0.1 first. You can see download link and some intruction at this page:
http://www.geeetech.com/forum/viewtopic ... 14&t=16097
After you download Aduino IDE and unzip it. You can intall 2560:
Computer>Manage>Device manager>....when you connect the mainboard to computer, you can see a new COM port under Device manager. Then you click right button of mouse, and you can manually loate the install directory.
It is under: arduino-1.0.1-windows\arduino-1.0.1\drivers
Before that , you should intall Arduino IDE 1.0.1 first. You can see download link and some intruction at this page:
http://www.geeetech.com/forum/viewtopic ... 14&t=16097
After you download Aduino IDE and unzip it. You can intall 2560:
Computer>Manage>Device manager>....when you connect the mainboard to computer, you can see a new COM port under Device manager. Then you click right button of mouse, and you can manually loate the install directory.
It is under: arduino-1.0.1-windows\arduino-1.0.1\drivers