Geeetech

Hi everyone,

Recently, I received mi Prusa I3 Acrylic, but I got some problems assembling it. Until now, I was using http://www.geeetech.com/wiki/index.php/ ... ction(8mm) to assemble it. However, it's missing some details.
I need help with three little problems:

1-The instruction doesn't show how the Ramp 1.4 fits on this part. I Still got mi part next to the printer just to be safe.
I think should go like this: (The picture is just one i Google up)

But right now the hole arrangement are like this: https://www.dropbox.com/s/vyr2ttjeofrq0 ... 1.jpg?dl=0

2- I was verifying the board connection and notice the kits only contained one of this cables.

So, without another connector I cannot plug the 2 x Z stepper motor to the RAMP 1.4. Any suggestion?

3- I haven't connected the board to mi pc. but, does the board has the firmware uploaded?

Any solution other than ordering one.
Thank you in advance.
Ps. Any suggestion on wire arrangement, I got a mess of wire.

1. Rotate the mainboard clockwise by 90 degrees. You can find 4 holes on acrylic board can fit the mainboard.
2. I am sorry for that is our carelessness that we left 1 Dupont out. Please contact the customer service.
3. You can see where to download Arduino IDE and how to do at this page:
http://www.geeetech.com/forum/viewtopic ... 14&t=16097
After you unzip the file. Connect your printer to PC via USB cable. You computer will install 2 of 3 drivers. You should install the rest one yourself, please refer to this page:
http://www.geeetech.com/wiki/index.php/ ... he_drivers
You can find installation driver at : arduino-1.0.1-windows\arduino-1.0.1\drivers