Geeetech

Posted: **Wed Feb 11, 2015 10:57 pm**

Hello,

juste received my Acrylic Geeetech I3 3D printer.

I have found the guide in the wiki to build the printer, but I don't see where are the instructions to wire all the cables and electronic ....

Can you please give me the link ?

Thanks !

Carmelo

Posted: **Thu Feb 12, 2015 9:48 am**

Please tell me the type of mainboard. If you don't know its type. Send a picture to me.
By the way, I will give the wikipages of 2 types of mainboard, where you can find the wiring of mainboard.
http://www.geeetech.com/wiki/index.php/Ramps1.4
http://www.geeetech.com/wiki/index.php/Sanguinololu
You can see the wiring at the chapter 2.
The picture below shows how to connect the power unit.

: initpintu_副本_副本.jpg (122.35 KiB) Viewed 6289 times

: QQ截图20150211092118.png (195.88 KiB) Viewed 6289 times

: QQ截图20150212094622.png (381.93 KiB) Viewed 6289 times

If you still have any problem, reply me. You'd better add a pciture.

Geeetech

How to wire Acrylic Geeetech I3 ?

How to wire Acrylic Geeetech I3 ?

Re: How to wire Acrylic Geeetech I3 ?