Alum. I3 Z axis motors moving in opposite direction.

Post Reply
mesamike
Posts: 6
Joined: Fri May 20, 2016 10:33 am

Alum. I3 Z axis motors moving in opposite direction.

Post by mesamike » Thu Jul 07, 2016 6:56 am

Z axis motors moving in opposite directions. Sanguinololu. Connected to Dupont cable.
Top
User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Alum. I3 Z axis motors moving in opposite direction.

Post by William » Thu Jul 07, 2016 3:44 pm

mesamike wrote:Z axis motors moving in opposite directions. Sanguinololu. Connected to Dupont cable.
Hi,
You can change the corresponding settings here in the configuration.h tab of your firmware and upload it to your printer.Refer this article below:
http://www.geeetech.com/forum/viewtopic ... 17&t=17037
-Keep your mind and try to test it. :)
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Top
Post Reply

Return to “Assembly”