After assembly Prusa i3x problems

[drixtc]

Prusa i3x not working

nr. 1 the end stop

Y and X axis End stopper seem not been working - its like they still have force on them when they hit the end stop



nr.2 Z axis not moving

Z axis motors are doing somtheng but not moving the z axis
(not) i can turn the bearing on the both sides even tough the screws are lock tied - ( did already use some wd40 on roads. )



nr.3 Heat beed and extruder not heating

[Mark]

1. the endstops, is your home working well? if it is then don't worry about this.
2. is your Z axis motor working well when removing the coupling? and the 2 sides of your X axis are the same height to the heatbed? if not it will hard to move the Z axis up and down. And the Z axis driver will need more power to drive the Z axis cause it has two motors.
3. as for this one, check this link first:
http://www.geeetech.com/forum/viewtopic ... 19&t=17039

[drixtc]

1. yes the end stops works. its was just my thinking they where not working
2. just needed to tight the screws on the bearing more and put more wd-40 on it
3. i had the thermistor for the heater of the extruder on the wrong place one the motherboard