Prusa I3 Aluminium - Cut out for LCD display backwards

[eikeland]

Hi,
I try to assemble my I3 Alum. kit, but it is a manufacture issue for the LCD Display cutout, it's bakwards (mirrored).

Please see the image:

Cut out for LCD display backwards

IMG_0087c.jpg (215.49 KiB) Viewed 8811 times

[Mark]

maybe you have the wrong instructions, check PDF page19 here:

QQ截图20151114100745.jpg (198.49 KiB) Viewed 8808 times

QQ截图20151114101314.jpg (278.16 KiB) Viewed 8808 times

[eikeland]

Hi,
I do not have that instruction.
Could you please post or email me the latest instruction?

[SAMS]

Hi, I can confirm this issue, I'm running in the very same problem...
Apparently, we are not alone
http://www.geeetech.com/forum/viewtopic ... 22&t=16942
http://www.geeetech.com/forum/viewtopic ... 22&t=16926

Where can we find the good instruction for the new FULL aluminum Prusa I3 ?

Sanguino headers are 90° so it collide X axis motor if you mount as instructed.

sanguino.png (378.89 KiB) Viewed 8780 times

[Mark]

For those who's headers are 90°, you can mount it as this file shows:

mount the control board.zip

(559.12 KiB) Downloaded 514 times

And the latest PDF for this printer is here(please ignore the old pictures in it, just mount it on the left of your frame)

Aluminum Prusa i3 Assemble Instruction.zip

(2.27 MiB) Downloaded 1058 times

[SAMS]

There is no M3x40 left (There were only 2), I have 2 M3 washer left and I never had those aircraft spacers nor the long spacer tubes...
So I just made 6 holes (4 taped for the board) at the right place, like on the old frame.

Other problems, the fan have 3 pins connectors with the wrong spacing for the 2 pins headers and end-stop have one joined pins connector instead 2 single pin connector.
I removed the connectors plastic shell and plugged the pins directly to the header pins

I'm not sure anyone even try to fully assemble this new modified full aluminum kit...