Geeetech

Hello everyone,,
When I send a file to my printer, I press print, and the stepper moters go the oposite direction as where the endstops are.
(1) should I make a video because that was not very clear mobdro lucky patcher kodi
(2) If you understood it, is there a solution?

Hi, If you mean that the motor is running in the opposite direction than expected,
You need to change the motor's running direction in the firmware.

For specific operations, you can refer to: viewtopic.php?f=17&t=17037

Steeper motors have the ability to spin in the wrong direction and this is a question by the pst makers. The 3D software printer by the Gree technology has shared the answer and https://www.australian-writings.org/ follow up the post in the proper kind of the mode and stations.

Question here is the stepper motors spin in the wrong direction with the 3 D printing software installation as well. The content is going to the dimension of the Phoenix iv therapy with the quality situation and the move of great dimensions for the year to understand.