Geeetech i3 pro and Cura X,Y offset
Posted: Wed Jan 01, 2020 3:40 pm
Hello everyone,,
I have a Geeetech i3 pro and I am using Cura software to set up my prints. I then upload the prints onto a Pi with octoprint loaded on to it and use this to drive the printer.reversephonelookup.onl/ curated.onl/nba-reddit/ pcbuilder.onl/pcpartpicker/
My question is about the start of printing - on some prints, everything works well, but some of them it prints off the bed and I want to know if there is a way of setting an offset for X and Y to ensure it always starts printing on the bed. Can this be set on the printer itself so it always remembers it or do I need to do it in the software (Cura or Octoprint).
Many thanks in advance.
I have a Geeetech i3 pro and I am using Cura software to set up my prints. I then upload the prints onto a Pi with octoprint loaded on to it and use this to drive the printer.reversephonelookup.onl/ curated.onl/nba-reddit/ pcbuilder.onl/pcpartpicker/
My question is about the start of printing - on some prints, everything works well, but some of them it prints off the bed and I want to know if there is a way of setting an offset for X and Y to ensure it always starts printing on the bed. Can this be set on the printer itself so it always remembers it or do I need to do it in the software (Cura or Octoprint).
Many thanks in advance.
Hi,You can set the printing range of the printer in the printer settings of Cura.