Geeetech

Hi everyone

Just received my Geeetech A30 printer, loaded Cura 4 and used the creality cr10 profile, the printed bench boat was perfect. Change the printer to the default geeetech a30 cura 4 ships with and tried another print, it was terrible, could not compare. So i noted the creality cr10 profile was far superior in print quality.

After some thought, before i try larger prints please could you help me confirm the print head settings are correct? See attached image.

Hi, Your printhead settings should be changed.
If you are using cura4.4, you can find the A30 printer.

Hi William

I tested the A30 profile in Cura 4 and the print was terrible, using the creality cr10 profiles my prints were perfect. however this was tested in a 150mm x 150mm x 150mm model, i am afraid to use the same creality cr10 profile print head settings for much larger prints. Please could you help me with configuring the Cura 4 creality cr10 profile print head settings to work as it should with the A30?

Hi, I find this. and you can refer to this:https://www.youtube.com/watch?v=yY2QvpWOXYE

William wrote: ↑

Wed Dec 04, 2019 9:11 am

Hi, I find this. and you can refer to this:https://www.youtube.com/watch?v=yY2QvpWOXYE

Thank you for posting something like this